7.3.5.5 Corner-blade machine parameters
Basic positioning of the corner blades to the seam is carried out in the
machine-parameter program.
–
Select “corner-blade machine parameters ”withcursorkeys“ï”
or “ð”.
A black background appears behind the symbol.
–
Press OK to start the program.
The code-number entry box appears in the display.
–
Enter code number “25483” on the decimal keypad.
The corner-blade correction screen appears.
Info line:
Seam-end corner-blade correction value
To correct the corner incisions and the center-blade cut a sewing piece
should first be prepared and sewn. The procedure is as follows:
–
Set up a test program on the controller and set all corner- and
center-blade corrections to “0".
–
Iron a piece of Vlieseline
â
onto the sewing piece.
This shows up the corner incisions better.
–
Sew a test seam.
–
Check the seam and cut pattern.
–
To leave the test program press function key F1.
62
To Next Page
Loading...
Need help?
General
