Corner-blade settings for angles
This parameter tells the controller whether the corner blades are to be
set manually or automatically.
Manual corner-blade positioning
Automatic corner-blade positioning
Maximum sew ing length
Entry: 180, 200, 200
*
, 220 [mm]
Select with the “ò”or“ñ”keys.
Folder unit
Entry: A, B, D, F
A: piped pockets,
manual positioning of piping strip,
flaps and other items
B: piped pockets,
automatic piping-strip feed
with incision of the ends
D: breast-welt pockets,
automatic breast-welt feed and alignment
F: piped pockets,
automatic piping-strip feed,
automatic flap feed and alignment,
incision of piping ends
Needle distance
Entry: 10, 12, 14, 16, 18, 20, 22, 24, 26, 28, 30 [mm]
Sw itching t he thread monitor on/off
This parameter switches the needle-thread and looper-thread monitor
on and off.
Entry: on/off
41
4
To Next Page
Loading...
Need help?
General
