Contents page:
7.3.6 Testing needle and center-blade activation .............................. 64
7.3.7 Checkingthetapefeed.......................................... 65
7.3.8 Checking the gripper folder without feed clamp (versions B and F only) ............. 66
7.3.9 Checkingtheinsertionprocesswithfeedclamp........................... 67
7.3.10 Checkingandadjustingthepipingknives............................... 68
7.3.10.1 Checkingthepipingknifemotion.................................... 68
7.3.10.2 Settingthepipingknifereferenceposition .............................. 69
7.3.11 Step-by-stepmode ............................................ 70
7.3.12 Determiningthecycletime........................................ 71
7.3.13 Dongle Menu ................................................ 71
7.4 Multitestsystem.............................................. 72
7.4.1 Displaying the program version and checksum............................ 73
7.4.2 TestingRAM ................................................ 74
7.4.3 Selecting input elements ......................................... 75
7.4.4 Checking input elements ......................................... 77
7.4.5 Selectingoutputelements........................................ 78
7.4.6 CANtest................................................... 81
7.4.7 Checkingthesewingdrive........................................ 82
7.4.8 Errorlist................................................... 83
7.5 Terminalself-test ............................................. 84
7.6 Displaycontrastvalue .......................................... 85
7.7 Editing menus ............................................... 86
7.8 Adjustingtheserialinterface ...................................... 87
8. Error messages
8.1 Sewing motor controller error messages ............................... 88
8.2 Stepping motor error messages..................................... 89
8.3 Operating indicator error messages .................................. 89
To Next Page
Loading...
