Error number Meaning Remedy
Info 9000 Reminder to execute the reference
run after switching on
Push left pedal backwards
Info 9001 Corner-blade station is swivelled out
Swivel corner-blade station in
Error 9001 Corner-blade station swivelled out
during sewing.
Push the left pedal backwards: the
feed carriages moves backwards and
a reference run is executed.
Check/adjust the fastening of the
corner-blade station.
Info 9002 Folder station is swivelled out
Swivel folder station in
Error 9002 Folder station swivelled out during
sewing.
Push the left pedal backwards: the
feed carriage moves backwards and
a reference run is executed.
Check/adjust the fastening of the folder
station.
Info 9013 Tape missing
Insert tape
Info 9014 The adjusted position for the feed
clamp does not fit the built-in stamp.
Adjust the position of the feed clamp to
match the one displayed in the pocket
parameters.
Info 9015 Incorrect setting of the flap scanning
in the pocket program
Correct the pocket program
Error 9601 Left pedal pushed backwards during
sewing
To clear this error, operate the pedal
again; the feed clamp then moves to its
rear position
Error 9604 Light barrier (s10) for material
removal not active
Adjust the light barrier (s10) for material
removal
Error 9700 Folder not up Correct the folder setting (mechanical
collision; check switch)
Error 9701 Folder not down
Correct the folder setting (mechanical
collision; check switch)
Error 9702 Folder not vertical
Correct the folder setting (mechanical
collision; check switch)
Error 9703 Folder not slanted
Correct the folder setting (mechanical
collision; check switch)
Error 9704 Folder not on piping table
Correct the folder setting (mechanical
collision; check switch)
92
To Next Page
Loading...
Need help?
General
