Programming
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 147
To set the Global parameters:
1. Press the desired button.
The user interface for setting the desired item is displayed.
Maximum hook thread counter
• only visible in global parameters if hook thread monitor is
deactivated in the Machine configuration p. 137
• Maximum hook thread counter On/Off
• Use the numeric keypad to enter the length of the hook thread
in meters which will fit on the bobbin
Needle thread monitor On/Off
Transport clamp mode (745-35-10 A only)
• without bypass
• bypass left
• bypass right
• bypass left and right
Set password protection
Set counting direction of piece counter UP
OR
Set counting direction of piece counter DOWN
Symbol Description
To Next Page
Loading...
