DURKOPP ADLER 756 A

Programming
270 Service Instructions 755 A/756 A - 00.0 - 02/2019
5.1.10.4 Set clamp speed while transport  p. 329
5.1.11 Transport clamp  p. 330
5.1.11.1 Set return speed  p. 330
5.1.11.2 Set insertion speed  p. 330
5.1.11.3 Softstart for insertion speed  p. 330
5.1.11.4 Return of transport clamp  p. 331
5.1.11.5 Waiting position of transport clamp  p. 332
5.1.12 Process of transport clamp  p. 333
5.1.12.2 Select process of transport clamp  p. 334
5.1.12.3 Select piping type  p. 335
5.1.12.4 Spread transport clamp  p. 336
5.1.12.7 Set transport clamp pressure  p. 333
5.1.13 Program loading process  p. 337
5.1.13.1 Select flap clamps  p. 337
Vacuum On/Off  p. 337
Downholder On/Off  p. 337
5.1.13.4 Select downholder mode  p. 339
Waistband clamp On/Off  p. 337
5.1.13.6 Select pocket bag clamp mode  p. 338
5.1.13.7 Select blowing mode  p. 341
Breast welt mode On/Off  p. 338
5.1.13.10 Select pedal mode  p. 344
5.1.15 Stacker/smoother/blow-off/roll-off  p. 345
Stacker On/Off  p. 345
5.1.15.1 Select clamping time  p. 345
Smoother On/Off  p. 345
Set smoother: Start after corner cut  p. 345
5.1.15.3 Set duration of grip stacker signal  p. 345
5.1.15.4 Lift transport clamp after corner cut  p. 345
Blow-off On/Off  p. 345
5.1.15.11 Set blow-off time  p. 345
Roll-off On/Off  p. 345
5.1.15.6 Outfeed roller: Time after corner cut  p. 346
Menu item
Option/described
on page