Thread cutter
Service Instructions 667 - 00.0 - 04/2016 69
Important
If the cutting pressure is too high, the thread cutter magnet will not swivel
out the thread-pulling knife. The thread will not be cut.
To check the cutting pressure:
1. Turn the handwheel until the thread-pulling knife (2) can be swung out
by hand.
2. To do this, press the block (3) with the roller (4) to the right against the
control cam.
The thread-pulling knife (2) swivels out.
3. Insert 2 threads to be cut into the thread-pulling knife (2).
4. Turn the handwheel further until the thread-pulling knife (2) is swiveled
down.
5. Check whether the threads have been cleanly cut.
To set the cutting pressure:
1. Turn the screw (1).
• greater cutting pressure: turn clockwise
• lower cutting pressure: turn counterclockwise
2. Check the setting and correct it if necessary.
To Next Page
Loading...
