Sewing feet
Service Instructions 667 - 00.0 - 04/2016 55
11.2 Setting the stroke movement for the feeding foot
In order to ensure a correct feed, the stroke movement for the feeding foot
must be aligned to the stroke movement for the feed dog.
Order
First, check the following settings:
• Feed dog movement ( p. 38)
• Even sewing foot stroke ( p. 54)
Proper setting
Left adjusting wheel for the sewing foot stroke set to 9 and the upper stitch
length adjusting wheel to 0.
The feeding foot (1) touches down exactly on the feed dog (2) when
the downward movement of the needle tip (3) reaches the upper
edge of the feeding foot. This will occur when the handwheel is in the
95° position.
Fig. 36: Setting the stroke movement for the feeding foot (1)
Cover
• Arm cover ( p. 10)
WARNING
Risk of injury from sharp and moving parts!
Crushing and puncture possible.
Switch off the machine before you check and set
the stroke movement for the feeding foot.
(1) - Feeding foot
(2) - Feed dog
(3) - Needle tip
To Next Page
Loading...
Need help?
General
