EasyManuals Logo

Dynapac CC1000 User Manual

Dynapac CC1000
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
Maintenance - 2000h
4812160801_D.pdf 2018-12-17
Hydraulic reservoir - Check/venting
Figure. Engine compartment, right side
1. Hydraulic fluid tank cap
1
Unscrew and make sure that the reservoir cap is not
blocked. Air must have unobstructed passage through
the cap in both directions.
If blocked in either direction, clean with a little diesel oil
and blow with compressed air until unblocked or
replace the cap with a new one.
Wear eye protectors and gloves when working
with compressed air.
Wear eye protectors and gloves when working
with compressed air.
Fig. Engine compartment, right side
1. Sight glass
1
Check the hydraulic oil level in the sight glass (1) and
top off where necessary. See under the heading
‘Every 10 hours of operation’.
102

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac CC1000 and is the answer not in the manual?

Dynapac CC1000 Specifications

General IconGeneral
BrandDynapac
ModelCC1000
CategoryConstruction Equipment
LanguageEnglish

Related product manuals