Operation
4812160801_D.pdf2018-12-17
Manual vibration - Switching on
4
Fig. Forward/Reverse lever
4. Switch, vibration On/Off
Vibration should not be active when the roller is
stationary. This can damage both the surface and
the machine.
Vibration should not be active when the roller is
stationary. This can damage both the surface and
the machine.
Engage and disengage vibration using the switch (4)
on the underside of the forward/reverse lever.
Always switch off vibration before the roller comes to a
standstill.
Braking
Normal braking
Braking is normally activated using the
forward/reverse lever. The hydrostatic transmission
brakes the roller when the lever is moved towards the
neutral position.
Press the switch (4) to switch off the vibration.
4
31
2
3
6
Figure. Control panel
2. Engine speed control
3. Emergency stop
4. Vibration On/off
6. Forward/reverse lever
31. Parking brake
Move the forward/reverse lever (6) to the neutral
position to stop the roller.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
Never leave the operator platform without
activating the parking brake (31).
Never leave the operator platform without
activating the parking brake (31).
43
To Next Page
Loading...
Need help?
General
