Safety - when operating
4812160801_D.pdf2018-12-17
Safety - when operating
Prevent persons from entering or remaining in
the danger area, i.e. a distance of at least 7 m
(23 ft) in all directions from operating machines.
Prevent persons from entering or remaining in
the danger area, i.e. a distance of at least 7 m
(23 ft) in all directions from operating machines.
The operator may allow a person to remain in
the risk zone, however he/she must be attentive
and operate the machine only when the person
is fully visible or has given a clear indication of
where he or she is.
The operator may allow a person to remain in
the risk zone, however he/she must be attentive
and operate the machine only when the person
is fully visible or has given a clear indication of
where he or she is.
Avoid driving across a slope. Drive straight up
and down sloping ground.
Avoid driving across a slope. Drive straight up
and down sloping ground.
Sitting position
Fig. Seat position
1. ROPS
2. Seat belt
2
1
Remain seated at all times when operating the roller. If
the operator stands up during operation, a buzzer
sounds. After 4 seconds the brakes are activated and
the engine stops. Brace yourself for a sudden stop.
Always use the seat belt where fitted. Where the
seat belt is not used, there is a great risk that the
operator will be thrown off and land under the
machine if the machine topples over.
Always use the seat belt where fitted. Where the
seat belt is not used, there is a great risk that the
operator will be thrown off and land under the
machine if the machine topples over.
The seat belt is standard equipment on rollers fitted
with Roll Over Protective Structure (ROPS) (1).
ROPS should always be in the raised position
when machines with foldable ROPS are operated
ROPS should always be in the raised position
when machines with foldable ROPS are operated
Work driving
Avoid operating close to edges and ditches and the
like as well as on poor ground conditions that influence
the bearing strength and capacity to support the roller.
Pay attention to potential obstacles above the
machine, such as overhead cables and the branches
of trees etc.
Pay particular attention to the stability of the substrate
when compacting close to edges and holes. Do not
compact with a large overlap from the previous track in
7
To Next Page
Loading...
Need help?
General
