Maintenance, 10h
4812160801_D.pdf 2018-12-17
Hydraulic reservoir, Level check - Filling
Fig. Hydraulic reservoir
1. Sight glass
2. Filler hose
1
2
Wipe the sight glass (1) clean. Check that the fluid
level is between the min. and max. markings. Where
required, top off with fresh hydraulic fluid through the
filler hose (2).
See under the heading ‘Lubricants’ for the correct fluid
grade.
Check - Coolant system
Figure. Cooling water container
1. Filler cap
2. Level marking
1
2
Check that all hoses/hose connectors are intact and
tight. Fill with coolant as specified in the lubricants
specification.
Take great care when opening the radiator cap
while the engine is hot. Wear protective gloves and
goggles.
Take great care when opening the radiator cap
while the engine is hot. Wear protective gloves and
goggles.
Also check the freezing point. Change the coolant
every other year.
Also check the freezing point. Change the coolant
every other year.
72
To Next Page
Loading...
Need help?
General
