Technical specifications
4812160801_D.pdf2018-12-17
ROPS - bolts
Bolt dimensions : M12 (PN 4700508063)Bolt dimensions : M12 (PN 4700508063)
Strength class : 8.8Strength class : 8.8
Tightening torque : 70 NmTightening torque : 70 Nm
ROPS-bolts which are to be torque tightened
must be dry.
ROPS-bolts which are to be torque tightened
must be dry.
Hydraulic system
Opening pressure MPa PsiOpening pressure MPa Psi
Drive system 35,0 5076Drive system 35,0 5076
Supply system 2,0 290Supply system 2,0 290
Vibration system 22,0 3190Vibration system 22,0 3190
Control systems 7,0 1015Control systems 7,0 1015
Brake disengagement 2,0 290Brake disengagement 2,0 290
Slopes
Max 20° or 36%Max 20° or 36%
This angle has been measured on a hard, flat surface
with the machine stationary.
The steering angle was zero, the vibration was
switched OFF and all tanks were full.
Always take into consideration that loose ground,
steering the machine, vibration on, machine speed
across the ground and raising the center of gravity can
all cause the machine to topple at smaller slope
angles than those specified here.
19
To Next Page
Loading...
Need help?
General
