EasyManuals Logo

Dynapac CC1300C User Manual

Dynapac CC1300C
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
Miscellaneous
4812161201_F.pdf 2018-04-17
1
2
3
4
Fig. ROPS locking device
1. Tensioning screw
2. Pin
3. Stud
4. Rubber buffer
To retract the ROPS, release the tensioning screw (1),
and pull out the pin (2) and stud (3). Do the same on
both sides. Lower the ROPS backwards if there is
space.
Remember to dismantle the rotating warning light
before lowering the ROPS.
Remember to dismantle the rotating warning light
before lowering the ROPS.
After lowering the ROPS, replace the pin and stud.After lowering the ROPS, replace the pin and stud.
To lift the ROPS proceed in the reserve order.
Always make sure the ROPS is locked in raised
position before operation.
Always make sure the ROPS is locked in raised
position before operation.
Grease the tensioning screw (1) and stud (3)
periodically.
56

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac CC1300C and is the answer not in the manual?

Dynapac CC1300C Specifications

General IconGeneral
BrandDynapac
ModelCC1300C
CategoryConstruction Equipment
LanguageEnglish

Related product manuals