Eaton 93PR Series

To Next Page

To Previous Page

CAUTION

• Installation or servicing should be performed by qualied service personnel knowledgeable of

batteries and required precautions. Keep unauthorized personnel away from batteries. Consider all

warnings, cautions, and notes before installing or replacing batteries. DO NOT DISCONNECT the

batteries while the UPS is in Battery Mode.

• Please read the installation instructions before connecting to the power source.

• Check whether any battery is accidentally grounded. If any, remove the grounded power supply. An

electric shock may be caused by touching any part of a grounded battery.

• For battery replacement, use batteries of the same type and specications as those originally used

in the UPS system.

• Disconnect the charging power supply before connecting or disconnecting terminals.

• Dispose of used batteries properly. Refer to the local disposal regulations.

• Do not throw the battery into a re, as it may explode.

• Keep the UPS door closed to maintain appropriate cooling air ow. This can also protect the

operators from being injured by hazardous voltage inside the equipment.

• Never operate the UPS system near any source of gas or electrical heat.

• Keep the operating environment within the parameters specied in this manual.

• Follow all “Danger”, “Attention” and “Instructions” warnings afxed to the inside and outside of the

equipment.

CAUTION

To prevent damage to the wiring channel and wiring in the UPS cabinet base when lifting or moving the

cabinet:

• Use only the left or right forklift slot to lift and move a packed cabinet.

• Make sure that the forklift fork is inserted into the forklift slot at the horizontal position. Do not tilt

the fork upwards.

• Insert the forks all the way through the base.

Damage to the wiring channels and wiring may be caused by failure to comply with these instructions.

• Do not open or disassemble the batteries. The released electrolyte may be toxic, which may harm the

skin and eyes.

• Important: If there are more than one batteries connected in parallel, the UPS must be disconnected

from all batteries before installation.

• The UPS can only be installed on concrete or nonammable surface.

Eaton 93PR Series - CAUTION