Eaton 93PR Series - Figure 6-27: Control Password Modification Interface; Figure 6-28: Control Password Modification Interface

61
Copyright © 2022 Eaton Corporation plc. All rights reserved.
The control password modication interface is used to modify the password for entering the
control interface. When the “Enable Control Password” button on this interface is clicked, the
keyboard and password boxes for modifying the control password will appear, as shown in Figure
6-28 . Then the control password can be modied.
Click the keyboard on the right side of the interface to enter the current password and the new
password, then click the “OK” button on the keyboard. If the password is veried, “New password
has been saved” will be prompted on the interface, as shown in Figure 6-29 . If a wrong password
is entered, “Wrong password” will be prompted on the interface, which means that you need to
re-enter a password, as shown in Figure 6-30 .
Figure 6-27: Control password modication interface
Figure 6-28: Control password modication interface