Eaton 93PR 15-80 kW UPS
Installation and Operation Manual
46
Copyright © 2022 Eaton Corporation plc. All rights reserved.
Chapter 6 UPS OPERATING INSTRUCTIONS
This section will introduce how to use the color touch screen to operate the UPS.
See Section 6.1 or Section 6.2 for the relevant information.
NOTE
• Before UPS startup, please make sure that all installation work has been completed, and that the
initial startup has been performed by Eaton’s customer service engineers. Before the initial startup,
check all electrical connections to ensure successful installation and normal operation of the
system.
• Read this part of information in this manual before operating any control devices, and have a full
understanding of UPS operations.
• The UPS can work at any of the following three rated voltages: 220/380,230/400 or 240/415VAC.
Before UPS operation, conrm the rated voltage and frequency of the UPS via the Settings ->
System Information on the screen. If the UPS has to work at other voltages or frequencies, please
contact the nearest Eaton ofce or the Eaton authorized dealer.
• The UPS is not a measurement device. All measurements displayed are approximate values.
6.1. UPS Control Panel and Indicator Lamps
This section introduces the control panel and indicator lamps of the UPS, which is used for controlling and
monitoring the UPS operations. Shown in
Figure 6-1
are the UPS control panel and indicator lamps.
6.1.1. Control Panel
The control panel is used to set up and control the UPS, and to monitor UPS operation. For a
description of the UPS control panel functions, see Section
6.2
.
To Next Page
Loading...
