Eaton 93PR Series - Figure 6-11: Confirmation Interface; Figure 6-12: UPS Interface

Eaton 93PR 15-80 kW UPS
Installation and Operation Manual
54
Copyright © 2022 Eaton Corporation plc. All rights reserved.
Figure 6-11: Conrmation interface
On the UPS control interface, you can test the battery, turn on a single UPS, shut down a single
UPS, turn on the battery charger, or turn off the battery charger. When the button is gray, it
indicates that this button is currently null. On the top of the interface, you can view the UPS status
and battery status.
If there is only one UPS in the system, the shutdown button on the interface will be disabled,
and the single-UPS shutdown button will be enabled. For the operating methods of the function
buttons on this interface, please refer to the method for switching to the bypass mode.
Figure 6-12: UPS interface
On the UPM control interface, you can view the UPS status, battery status, and UPM status, as
shown in
Figure 6-13 . Click on the interface > to enter the UPM shutdown interface, as shown in
Figure 6-14 . When the button is gray, it indicates that this button is currently null. The UPM will
be shut down upon a click of the “Shutdown” button on the interface.