Eaton DS7 - Part Numbers; Replacing Soft Starters

8 SmartWire-DT
8.7 Part numbers
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com 149
8.7 Part numbers
The following part numbers belonging to the DS7 series of soft starters are
capable of communicating with SmartWire-DT:
Table 27: DS7 part numbers for connecting
to SmartWire-DT
8.8 Replacing soft starters
If you replace a DS7-SWD soft starter in a supply system, you will have to
press the configuration button after replacing it and switching on the voltage.
This ensures that the new soft starter is assigned a network address.
￫
The SWD-Assist software is available free of charge on the
Internet at:
http://www.eaton.de/EN/EatonDE/ProdukteundLoesungen/Electrical/
Kundensupport/index.htm
￫ Customer support ￫ Download Center – Software
Frame size Part no. DS7…
1 DS7-34DSX004N0-D
DS7-34DSX007N0-D
DS7-34DSX009N0-D
DS7-34DSX012N0-D
2 DS7-34DSX016N0-D
DS7-34DSX024N0-D
DS7-34DSX032N0-D
3 DS7-34DSX041N0-D
DS7-34DSX055N0-D
DS7-34DSX070N0-D
DS7-34DSX081N0-D
DS7-34DSX100N0-D
4
DS7-34DSX135N0-D
DS7-34DSX160N0-D
DS7-34DSX200N0-D

DANGER
Before replacing a DS7-SWD soft starter, make sure to switch
off the voltage and the entire SmartWire-DT system.
NOTICE
If a DS7-SWD soft starter is replaced, the order of SmartWire-DT
modules must not be altered.