0 About this Manual
0.1 List of revisions
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com 5
0 About this Manual
This manual contains special information that you will need to connect a soft
starter correctly and configure it to your requirements using the parameters.
The details apply to the indicated hardware and software versions.
The manual describes all construction sizes of the DS7 series soft starters.
Differences and special characteristics of each rating level and construction
size are listed accordingly.
0.1 List of revisions
The following significant amendments have been introduced since previous
issues:
0.2 Further manuals for this device
Further information can be found in the following manuals:
On “Soft starter”
• “Design of soft starters” - MN03902001Z-EN
(previous description AWB8250-1346D)
On “SmartWire-DT”
• “SmartWire-DT The system” – MN05006002Z-EN
(previous designation AWB2723-1617en)
• “SmartWire-DT module” – MN05006001Z-EN
(previous designation AWB2723-1613en)
• “SmartWire-DT Gateways” – MN05013002Z-EN
(previous designation AWB2723-1612en)
• “XIOC signal modules” – MN05002002Z-EN
(previous designation AWB2725-1452en
Publication date Page Subject new modified deleted
09/16 96 Extended functionality ✓
44 Actuation of resistive loads ✓
09/13 Fully revised; firmware version V46 ✓
07/12 145ff. Chapter “SmartWire-DT” ✓
All Complete revision ✓
11/11 89 Size 2 (16 - 32 A) – Isolated relay contacts
Size 3 and 4 (41 - 200 A) – Isolated relay contacts
✓
06/11 All Complete revision ✓✓
04/11 56 Configuration options of DS7 ✓
216 Power supply dependent data (further) ✓
19 Power values ✓
07/10 Initial issue
To Next Page
Loading...
