Eaton DS7 - 1.7 Technical data

1 Device series DS7
1.7 Technical data
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com 19
1.7 Technical data
1.7.1 Assigned motor outputs
The following motor outputs can be connected if using three-phase
asynchronous motors and a load suitable for soft starters.
Table 4: Assigned rated motor outputs for three-phase asynchronous motors
Part no. Soft starter’s rated
operational current
Assigned motor output
1)
at
I
e
(IEC)
2)
I
e
(UL)
3), 4)
230 V 400 V 200 V 230 V 460 V
50 Hz 50 Hz 60 Hz 60 Hz 60 Hz
A A kW kW HP HP HP
DS7-34xSX004N0-… 4 4.2 0.75 1.5 ¾ 1 2
DS7-34xSX007N0-…
7 7.6 1.5 3 2 2 5
DS7-34xSX009N0-…
9 9.6 2.2 4 2 3 5
DS7-34xSX012N0-…
12 14 3 5.5 3 3 10
DS7-34xSX016N0-…
16 17.5 4 7.5 5 5 10
DS7-34xSX024N0-…
24 25.3 5.5 11 7½ 7½ 15
DS7-34xSX032N0-…
32 34 7.5 15 10 10 25
DS7-34xSX041N0-…
41 42 11 22 10 15 30
DS7-34xSX055N0-…
55 54 15 30 15 20 40
DS7-34xSX070N0-…
70 68 15 37 20 25 50
DS7-34xSX081N0-…
81 80 22 45 25 30 60
DS7-34xSX100N0-…
100 96 30 55 30 30 75
DS7-34xSX135N0-…
135 130 30 75 40 50 100
DS7-34xSX160N0-…
160 156 45 90 50 60 125
DS7-34xSX200N0-…
200 192 55 110 60 75 150
1) Motor shaft output for normal four-pole internally and surface cooled three-phase asynchronous motors
(1500 rpm at 50 Hz or 1800 rpm at 60 Hz)
2) IEC: Mains voltage = Motor voltage (at load) 230 V, 400 V
3) Reduced overload current acc. to UL 508C
4) Mains voltage 208 V / 240 V / 480 V ↔ motor voltage 200 V / 230 V / 460 V