Eaton DS7 - Accessories; Protection, Short-Circuit Rating

9 Appendix
9.5 accessories
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com 221
9.5 accessories
9.5.1 Protection, short-circuit rating
Table 47: Fuses, semiconductor fuses
The following two tables, 48 and 49, provide additional information on the
high-speed semiconductor fuses.
Part no. Type “1” coordination Type 1 and 2 coordination Type 2 coordination
Cable and motor
protection
(I
q
≦ 50 kA)
1)
Cable and motor
protection
(I
q
≦ 100 kA)
Fusing with PKE
3)
Superfast
semiconductor
fuses
in addition to the
fuses for type 1
coordination
(I
q
≦ 100 kA)
Fuse holder
for semi-
conductor fuse
Part no. Part no. Part no. Quantity x Part no. Quantity x Part no.
DS7-34xSX004N0-… PKZM0-4 PKZM0-4 (+ CL-PKZ0) PKE12…-4 3 x 170M1359 3 x 170H1007
DS7-34xSX007N0-…
PKZM0-10 PKZM0-10 (+ CL-PKZ0) PKE12…-12 3 x 170M1361 3 x 170H1007
DS7-34xSX009N0-…
PKZM0-10 PKZM0-10 (+ CL-PKZ0) PKE12…-12 3 x 170M1362 3 x 170H1007
DS7-34xSX012N0-…
PKZM0-12 PKZM0-12 (+ CL-PKZ0)
2)
PKE12…-12 3 x 170M1362 3 x 170H1007
DS7-34xSX016N0-…
PKZM0-16 PKZM0-16 (+ CL-PKZ0)
2)
PKE32…-32 3 x 170M1364 3 x 170H1007
DS7-34xSX024N0-…
PKZM0-25 PKZM0-25 + (CL-PKZ0)
2)
PKE32…-32 3 x 170M1365 3 x 170H1007
DS7-34xSX032N0-…
PKZM0-32 PKZM0-32 + (CL-PKZ0)
2)
PKE32…-32 3 x 170M1366 3 x 170H1007
DS7-34xSX041N0-…
NZMN1-M50 / PKZM4-50 NZMN1-M50 / PKZM4-50 – 3 x 170M3013 3 x 170H3004
DS7-34xSX055N0-…
NZMN1-M63 / PKZM4-58 NZMN1-M63 / PKZM4-58 – 3 x 170M3013 3 x 170H3004
DS7-34xSX070N0-…
NZMN1-M80 NZMH1-M80 – 3 x 170M4008 3 x 170H3004
DS7-34xSX081N0-…
NZMN1-M100 NZMH1-M100 – 3 x 170M4008 3 x 170H3004
DS7-34xSX100N0-…
NZMN1-M100 NZMH1-M100 – 3 x 170M4008 3 x 170H3004
DS7-34xSX135N0-…
NZMN2-M160 NZMH2-M160 – 3 x 170M4010 3 x 170H3004
DS7-34xSX160N0-…
NZMN2-M200 NZMH2-M200 – 3 x 170M5008 3 x 170H3004
DS7-34xSX200N0-…
4)
NZMN2-M200 NZMH2-M200 – 3 x 170M5008 3 x 170H3004
1) Rated conditional short-circuit current Iq with PKZM…; rated short-circuit breaking capacity Icu with NZM… (according to IEC/EN 60947) for 230 V/400 V and with type
1 and 2 coordination. Auto-protected range – back-up fuse is not required.
2) + CL-PKZ0 = required current limiter
3) Wiring set PKZM0-XDM required
4) For DS7-34xSX200N0-…, only the following applies: I
q
≦ 80 kA