Eaton DS7 - Page 72

3 Installation
3.3 Flush mounting in control panel
68 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
▶ Insert the device fan’s plug connection into the connection opening you
just opened [4] until the lower securing point locks into place with a click.
Figure 49: Plugging in the fan connection
NOTICE
When inserting the device fan, make sure not to damage the
fan’s plug connections (pins) or connection cables.
￫
The device fan is temperature-controlled, always runs during
ramp times (t-Start, t-Stop), and will continue to run until the
heat sink cools down again. The fan is then automatically
switched off.
4
3
0
3
0
3
0
1
1
0
0
t-Stop(s)
U-
St
a
rt(%
)
t-Start(s
)
0
0
.
5