•
•
•
•
•
5.4.5 System Status
There are preset process variables in the controller configuration set at the factory that can be used directly for
programming. In addition to the input variables for various status queries, there is also an output variable, the
LIFE_LED. The selection can be found as follows:
Controller configuration→GLT3010_V2 →System→System state
The following statuses are described in detail in the following chapters:
StatusoftheCANbus
StatusoftheSIOX1..3extensionmodules
Statusofthebattery
StatusoftheDIPswitches
StatusoftheLifeLED
To Next Page
Loading...