ECKELMANN Compact GLT 3010 - Compile Project and Load into DDC



Firmware: V2.18 / V--
26.10.2022
66/119
8.2.2 Compile project and load into DDC
Compile project
Theprojectiscompletelycompiledviathemenuitem"Project→Compileall":
Load project into DDC
TheprojectistransferredtotheGLTx010viathemenuitem"Online→Login":
Practical tip
When creating the final program code, it has proven useful to use the "Clean up all" selection before
executing " Compile all"!

ATTENTION
The program is now only stored in the volatile memory of the controller. It is lost when the power
supply is switched off.
