ECKELMANN Compact GLT 3010 - Removal from the DIN Rail



Firmware: V2.18 / V--
26.10.2022
71/119
9.1.2 Removal from the DIN rail
Step 1: Detach all mating connectors with cables from the controller.
Step 2: Remove the device from the DIN rail (A) by swivelling(1.) upwards.
DANGER
Warning about dangerous electrical voltage! Danger of electric shock!Thesafetyregulationsand
work safety instructions mustbeobservedforthemounting.All plug connectors may only be inserted
and removed in a de-energised state, see chapter Handhabung breiter COMBICON-Stecker.
