M3 Vital Signs Monitor User Manual Installation of Monitor
- 12 -
NOTE:
1 Check all the functions of the monitor and make sure that the monitor is in good
condition.
2 If rechargeable batteries are provided, recharge them after using the monitor every
time to ensure the electric power is enough.
3 After long-time continuous running, please restart the monitor to ensure the monitor’s
steady performance and long lifespan.
4 If the system is not used for a longer period of time, its system time may be
inaccurate. In this case, reset the system time after powering on.
5 If the system time cannot be saved and resumes the default value after restart,
contact the service department of EDAN to replace the button cell in main board.
2.4 Connecting Sensor to Patient
Connect all the necessary patient sensors between the monitor and the patient.
NOTE:
For information on correct connection, refer to related chapters.
2.5 Checking the Recorder
If your monitor is equipped with a recorder, open the recorder door to check if paper is properly
installed in the slot. If no paper is present, refer to Chapter 6 Trend and Recording for details.
To Next Page
Loading...
Need help?
General
