M3 Vital Signs Monitor User Manual Introduction
- 14 -
NIBP: Systolic Pressure (SYS);
Diastolic Pressure (DIA);
Mean Pressure (MAP);
Pulse Rate (PR).
TEMP: Temperature (TEMP)
3.2 Screen Display
The monitor is equipped with LCD. The patient parameters, waveforms, alarm messages, patient
ID, time, monitor status and other information can be reflected from the screen.
If the monitor is outfitted with the modules SpO
2
, NIBP and TEMP, the three parameters SpO
2
,
NIBP and TEMP are onscreen in the general display mode. If the monitor is configured to the
double-parameter measuring function as NIBP+SpO
2
or NIBP+TEMP, double parameters will be
displayed onscreen. Also, the monitor can be configured to single parameter mode with SpO
2
measuring only or NIBP measuring only. In SpO
2
only or NIBP only measuring mode, the single
parameter of SpO
2
or NIBP is displayed.
The configuration is preset by the manufacturer; it cannot be changed by the user.
3.2.1 General Display Mode
The screen is divided into three areas:
1 Parameter area ①
2 Waveform/Trend list/Alarm list area ②
3 Information area ③ ④
Figure 3-2 Main Display with Waveform
To Next Page
Loading...
Need help?
General
