To Next Page

To Previous Page

M3 Vital Signs Monitor User Manual Maintenance/Cleaning

- 50 -

 Ethanol (75%)

 Isopropanol (70%)

 Cidex OPA (High level disinfection of intracavitary temperature probe only)

If Ethanol or Isopropanol is used for both cleaning and disinfecting, then a new cloth is required

to be used for the disinfection step.

WARNING

The monitor and reusable accessories shall be disinfected to avoid patient cross

infection.

CAUTION

1 Do not use any disinfectant containing additional active ingredients other than those

listed, such as disinfectant didecyl dimethyl ammonium bromide which contains

quanternary ammonium salt.

2 Although the monitor chemically resistant to most common hospital cleaners,

disinfectants and non-caustic detergents, different cleaners or disinfectants are not

recommended and may stain the monitor, such as disinfectant didecyl dimethyl

ammonium bromide which contains quanternary ammonium salt.

7.4.1 Disinfecting the Monitor

WARNING

Before disinfecting the monitor, make sure that the monitor is switched off and

disconnected from the power line.

To disinfect the monitor, follow these steps:

1. Switch off the monitor and disconnect it from the power line.

2. Wipe the display screen using a soft, clean cloth dampened with the disinfectant solution.

3. Wipe the exterior surface of the equipment using a soft cloth dampened with the disinfectant

solution.

4. Wipe off the disinfectant solution with a dry cloth after disinfection if necessary.

5. Dry the monitor for at least 30 minutes in a ventilated and cool place.

7.4.2 Disinfecting the Reusable Accessories

7.4.2.1 Disinfecting the Blood Pressure Cuff

Disinfecting the Cuff:

EDAN M3 User Manual

Other manuals for EDAN M3