EDAN M3 User Manual

M3 Vital Signs Monitor User Manual Other Functions
- 85 -
Chapter 11 Other Functions
11.1 Nurse Call
The monitor provides dedicated nurse call port which is connected to nurse call system through
the nurse call cable to perform the nurse call function.
NOTE:
Before using the function of nurse call, check if it is functioning normally.
11.2 Network
The monitor can be connected with PC through network port. Also, the monitor can construct
wireless network with router. Our company arranges the qualified engineers to install and set the
wired or wireless network for the user and test the corresponding performance. For details, please
refer to Patient Monitor Wireless Network Installation Guide.
NOTE:
1 Be aware that some network-based functions may be limited for monitors on wireless
networks in comparison with those on wired networks.
2 The obstacle may interfere with data transmission and even cause data loss.
3 Use the wireless device recommended by EDAN, otherwise some exceptional
situations such as frequent network disconnection may occur on the monitor.
4 When signal intensity is unstable, the quality of the signal transmission may be
degraded.
5 For detailed specifications of router, please refer to the router’s user guide.
6 When the monitor is connected to MFM-CMS via the wireless network, the user
should set the router to a secure encryption/authentication mode (Recommended
option: WPA2-PSK, with a high complexity, non-dictionary password).
11.3 Central Monitoring System
The monitor can be connected to the central monitoring system. Through the network:
1. The monitor sends patient information, real-time monitoring or measurement data to the
central monitoring system.
2. The real-time monitoring information is displayed on the central monitoring system as the
same to the monitor, and the central monitoring system can perform some bilateral control.
For example: changing patient information, receiving patient, discharging patient and so on.
3. The alarm information of bed side monitor is displayed on the central monitoring system For
example: audio alarm paused, audio alarm off and physiological alarm status and so on.
For detailed information, please refer to MFM-CMS Central Monitoring System User Manual.
NOTE:
1 MFM-CMS can display max 12 bits barcode.
2 Make sure the Free Online Mode in CMS is turned on when the barcode is more
than 12 bits, and then the monitor can display the real barcode.
3 When deploying the network of the monitor and MFM-CMS, it is recommended to
isolate the network and the Intranet system of the hospital by using VLAN so as to
ensure the network security.

EDAN M3 Specifications

General

Brand	EDAN
Model	M3
Category	Monitor
Language	English