M3 Vital Signs Monitor User Manual Trend and Recording
- 44 -
Chapter 6 Trend and Recording
In SELECTION submenu, the user can set the displayed contents to waveform, trend table or
alarm list which can be printed out via RECORD.
6.1 General Information on Recording
A thermal dot matrices recorder with printout paper of 48mm wide is used for the monitor.
Performance of the Recorder:
Set the displayed content via SYSTEM MENU > SELECTION, trend table or alarm list. Then
print it via RECORD.
Press the RECORD to print out the currently displayed content. Press the UP/DOWN button to
page up or down the screen, then press RECORD to print it out.
The real-time waveform of 8s can be printed out.
NOTE:
1 You can press the RECORD on the control panel to stop the current recording
process.
2 It is suggested that the user should not use the recorder when the low battery
displays, or the monitor may be turned off automatically.
6.2 Recorder Operations
Record Paper Requirement
Only standard thermosensitive record paper can be used, otherwise the recorder may not function,
the recording quality may be poor, and the thermosensitive printhead may be damaged.
Proper Operation
When the recorder is working, the record paper goes out steadily. Do not pull the paper
outward with force; otherwise the recorder may be damaged.
Do not operate the recorder without record paper.
Paper Out
When OUT OF PAPER alarm is displayed, the recorder cannot start. Please insert record paper
properly.
Inserting Paper
Pull outwards the upper arc part of the recorder casing to release the casing.
Insert a new roll of paper into the paper cassette, printing side facing upwards.
Ensure proper position and tidy margin.
Pull about 2 cm of the paper out, and then close the recorder casing.
To Next Page
Loading...
Need help?
General
