EDAN M3 - System Parameters and Structure; General System Structure and Parameter Flow

M3 Vital Signs Monitor User Manual Introduction
- 18 -
NIBP:
 SYS, DIA, MAP (Unit: mmHg or kPa, 1 mmHg=0.133 kPa)
 Pulse Rate (Pulse Rate, Unit: bpm)
 NIBP measuring mode
TEMP: Temperature (Unit: ℃ or ℉).
The PR signal from SpO
2
measuring takes priority to be displayed.
Waveform/Trend List/Alarm List Area (②)
It can display SpO
2
waveform, Trend tab or Alarm list. You can select it in the SELECTION of
SYSTEM MENU.
Information Area (③ ④)
The information areas are to display operating status of the monitor and condition of the patient,
including the following data:
 Patient type and ID;
 Signs indicating the net connection status;
 Signs indicating the battery or mains power supply status;
 Current time;
 Signs indicating the volume status;
 Alarms and prompts.
Alarm Indicator and Alarm Status
－ In normal condition, the alarm indicator does not light.
－ When an alarm is generated, the alarm indicator lights or flashes. The color of light represents
the alarm level. Refer to Chapter 5 Alarm for details.
－ Refer to relevant content of parameters for Alarm information and prompt.
Charging Indicator and Charging Status
To indicate the status of charging: when the battery is being charged, the light turns to yellow;
after the charge is finished, the light will be off.