M3 Vital Signs Monitor User Manual Introduction
- 22 -
All the operations to the monitor can be finished by several buttons.
When the monitor is off, press this button to switch on the
monitor. When the monitor is on, press this button for less
than 1 s, the monitor will enter the sleep mode (if
STANDBY is set to ON). Press this button and hold it for
≥ 2 s to switch off the monitor.
Press this button to pause or turn off the auditory alarm as
needed.
To inflate the cuff and start blood measuring. During the
measuring process, press the button to stop measuring.
(For the monitor with NIBP function).
For SpO
2
only monitor, the NIBP STASRT/STOP button
is changed to ALARM LIMIT button. Press this button to
set the alarm limit of the parameters of SpO
2
.
Press this button to switch between waveform display,
trend graph and trend list display.
HOT KEY
(RECORD/
SHORTCUT KEY
FOR CHANGING
PATIENT TYPE)
In the monitoring mode, this hot key is configured as the
record button by default. Press it, and you can print out the
currently displayed waveforms, trend graph, trend lists or
alarm lists. Pressing it while recording can stop recording.
In the spot check mode, this hot key is configured as the
shortcut key for changing the patient type. You can
rapidly alter the patient type by pressing this button.
Press to open the SYSTEM MENU. Refer to Chapter 4
System Menu for details.
Select the items in menu, or decrease or increase the
items. Confirm the selection by pressing OK.
To Next Page
Loading...
Need help?
General
