To Next Page

To Previous Page

M3 Vital Signs Monitor User Manual TEMP Monitoring (Optional)

- 75 -

2. Insert the probe into the probe cover on the probe cover loader until the probe cover clicks in place.

NOTE:

If the probe cover did not install well, the icon will flash on the LCD of the

thermometer, and you cannot take the ear temperature (with four beep sounds heard and

without reading on the LCD when measuring).

3. Press ON/MEM button of the thermometer. The icon will display on the LCD of the

thermometer and you will hear two beep sounds.

4. Gently pull the ear back to straighten the ear cannal and snugly fit the probe into the ear

canal, aiming towards the membrane of the eardrum to obtain an accurate reading.

NOTE:

For children over two-year old and adults: pull the ear straight up and back as shown below:

5. Press the “Scan” button for one second until you hear a long beep sound which signals the

end of the measurement, and results will be shown on the display of the monitor.

6. Before starting another measurement, wait until all icons stop flashing and two beep sounds

are heard.

WARNING

Replace the probe cover after each use to ensure an accurate reading and avoid cross

contamination.

NOTE:

1 The thermometer will automatically shut down after one-minute pending to extend

battery life.

EDAN M3 User Manual

Other manuals for EDAN M3