SE-1201 Electrocardiograph User Manual Operation Preparations
- 28 -
To turn off the Electrocardiograph:
♦ When operating on AC power
Hold down the key to display the hint System is shutting down… on the screen.
Then the device will be off a few seconds later. Remove the plug from the outlet.
♦ When operating on battery power
Hold down the key to display the hint System is shutting down… on the screen.
Then the device will be off a few seconds later.
NOTE:
1. When turning off the device, follow the above sequence strictly, or else there may be
something wrong on the screen.
2. Do not hold down the key when the device displays the hint information
System is shutting down… on the screen.
3.6 Loading/Replacing Recorder Paper
Four kinds of folded thermal paper can be used. For details on selecting the paper style, please
refer to Section 10.4.1 “Setup 1”.
NOTE:
1. When using the paper of 216mm in width, the two movable parts should be removed.
For more detailed information about removing the two movable parts, please contact the
manufacturer or the local distributor.
2. The exit edge can help you tear the recorder paper.
CAUTION
Make sure that the recorder paper, is installed in the center of the recorder, and the paper
edge is parallel with the casing edge in the direction of advancing paper, in order to avoid
paper deviation or damage to the paper edge.
When the recorder paper runs out or is not loaded, the hint message No Paper will appear on the
screen. Then you should load or replace the recorder paper immediately.
To Next Page
Loading...
