EDAN SE-601 Series - Page 20

SE-601 Series Electrocardiograph User Manual
- 13 -
Definitions of corresponding pins:
Pin Signal Pin Signal
1
GND
4
GND
2
GND
5
ECG Signal (input)
3
GND
6
ECG Signal (output)
4) USB Socket 1 / USB Socket 2 (Optional)
WARNING : Only the USB equipment recommended by the manufacturer can
be connected to the USB interface.
Definitions of corresponding pins:
Pin Signal Pin Signal
1
VBUS
3
D+
2
D-
4
GND
WARNING :
1. Accessory equipment connected to the analog and digital interfaces must be
certified according to the respective IEC/EN standards (e.g. IEC/EN 60950 for
data processing equipment and IEC/EN 60601-1 for medical equipment).
Furthermore all configuration shall comply with the valid version of the standard
IEC/EN 60601-1-1. Therefore anybody, who connects additional equipment to
the signal input or output connector to configure a medical system, must make
sure that it complies with the requirements of the valid version of the system
standard IEC/EN 60601-1-1. If in doubt, consult our technical service
department or your local distributor.
2. The summation of leakage current should never exceed leakage current limits
while several other units are used at the same time.