EDAN SE-601 Series - Chapter 9 System Setup; Work Mode Setup

SE-601 Series Electrocardiograph User Manual
- 69 -
Chapter 9 System Setup
After you turn on the device, the main interface1 pops up. Press the function key F5 below
to open the main interface2. Then press the function key F1 below Setup to open the
System Setup interface.
Figure 9-1 SE-601B / SE-601C System Setup Interface
Figure 9-2 SE-601A System Setup Interface
After setup, press Esc or the function key F5 below to return to the main interface1.
9.1 Work Mode Setup
When the cursor is on Work Mode on the System Setup interface, press Enter to open the
Work Mode Setup interface.
On the Work Mode Setup interface, you can set Work Mode, Manual Style, Rhythm Style,
Auto Style, Sample Mode, Record Sequence and Sample Time.