SE-601 Series Electrocardiograph User Manual
- 86 -
9.6.7 Notification Volume
After a complete ECG wave is printed, the electrocardiograph gives a short sound. When
Notification Volume is set to Off, there is no notification sound.
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Notification Volume item on
the Display&Sound Setup interface, and then press F1 or F2 to select an option. You can set
Notification Volume to Low, Medium, High or Off.
For SE-601A, press F1, F2, Tab or Shift + Tab move the cursor to the Notification Volume item
on the Sound Setup interface, and then press F3 or F4 to select On or Off.
9.7 Patient Question
Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor to Pat. Question on the System
Setup interface, and then press Enter to open the Patient Question interface.
Figure 9-16 SE-601B / SE-601C Patient Question Setup Interface
Figure 9-17 SE-601A Patient Question Setup Interface
After setup, press Enter to confirm. Then the System Setup interface appears.
For SE-601A, if you press Esc to exit the Patient Question interface after setup, a hint will pop
up to
prompt you to save these modifications.
9.7.1 Specifying ID Mode
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the ID Mode item on the Patient
To Next Page
Loading...
