SE-601 Series Electrocardiograph User Manual
- 38 -
Chapter 6 Entering Patient Information
After the electrocardiograph is switched on, the main interface1 appears.
6.1 Entering Patient ID
1. By default, the system generates the patient ID automatically. The range of the patient ID is 0
~ 1999, 999, 999.
2. Or the system can generate the patient ID according to the current time.
The procedures are as follows:
1) Press the function key F5 below to display the main interface2.
2) Press the function key F1 below Setup to open the System Setup interface.
3) Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor. When the cursor is on Pat.
Question, press Enter to open the Patient Question interface. The cursor is on the ID Mode
item.
4) For SE-601B/C, press F1 or F2 to select Time. For SE-601A, press F3 or F4 to select Time.
5) Press Enter to confirm.
6) Press Esc or the function key F5 below to return to the main interface1.
Then the system will generate the patient ID according to the time that you press the
START/STOP key to print an ECG report.
3. Or you can enter the patient ID manually.
The procedures are as follows:
1) Press the function key F5 below to display the main interface2.
2) Press the function key F1 below Setup to open the System Setup interface.
3) Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor. When the cursor is on Pat.
Question, press Enter to open the Patient Question interface. The cursor is on the ID Mode
item.
4) For SE-601B/C, press F1 or F2 to select Manu. For SE-601A, press F3 or F4 to select Manu.
5) Press Enter to confirm.
6) Press Esc or the function key F5 below to return to the main interface1.
7) Press the function key F1 below Patient to open the Patient Information window. Press Tab
or Shift + Tab to move the cursor. When the cursor is in the ID textbox, enter the patient ID
manually.
8) Press Enter to confirm.
Note: In the AUTO or RHYT mode, when ID Mode is set to Manu and ID Hint is set to
On, if you do not input the patient ID, the hint will pop up to remind you to input the patient
To Next Page
Loading...
