EasyManua.ls Logo

EDAN SE-601 Series - 4.2 Loading;Replacing Recorder Paper

EDAN SE-601 Series
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SE-601 Series Electrocardiograph User Manual
- 28 -
is weak, please recharge the battery first.
When the battery is fully charged, the electrocardiograph can work normally about 6
hours, and print about 280 ECG reports of 3×4+1rhy in the AUTO mode.
Please refer to the maintenance section for how to recharge the battery. When the
battery is being recharged, the electrocardiograph can be powered by the mains supply.
WARNING : Potential equalization bar of the unit should be connected to the
potential equalization terminal of the electrical installation when
necessary.
4.2 Loading/Replacing Recorder Paper
The recorder paper is the folded thermal paper.
Note: The exit edge can help you tear the recorder paper.
CAUTION : Make sure that the recorder paper is installed in the center of the
recorder, and the paper edge is parallel with the casing edge in the
direction of advancing paper, in order to avoid paper deviation or
damage to the paper edge.
When the recorder paper runs out or is not loaded, or the casing is not closed properly, the hint
message No Paper appears on the screen. Then you should load or replace the recorder paper
immediately.
Paper Tray
Casing Button
Casing

Table of Contents

Related product manuals