EDAN SE-601 Series - 7.2 Manual Mode

SE-601 Series Electrocardiograph User Manual
- 42 -
SE-601B / SE-601C Lead Setup Interface
SE-601A Lead Setup Interface
After setup, press Esc or the function key F5 below to exit the System Setup
interface.
3. Press the START/STOP key to print an ECG report. It will stop automatically after
printing a complete ECG report of 12 leads. Or press the START/STOP key again to stop
printing the report.
7.2 Manual Mode
Operation Method:
1. When the main interface1 is displayed, press the MODE key to select the MANU mode.
Press F2 to switch the gain. Press F3 to select a paper speed. Press F4 to set the EMG filter
and the Lowpass filter.
2. To set Manual Style or Lead Sequence (Optional)
When the main interface1 is displayed, press the function key F5 below
to open
the main interface2. Press the function key F1 below Setup to display the System Setup
interface and the cursor is on Work Mode. Press Enter to open the Work Mode Setup
interface.
1) For SE-601B/C, press F1 or F2 to select MANU. For SE-601A, press F3 or F4 to
select MANU.
2) For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Manual Style item,
and then press F1 or F2 to select a style.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Manual
Style item, and then press F3 or F4 to select a style.
3) Press Enter to confirm.