EDAN SE-601 Series - 3.5 About the System Setup Interface

SE-601 Series Electrocardiograph User Manual
- 22 -
pressing the function key F5 can switch the gain.
To Select the Next Patient Function
When the main interface2 is displayed, press the function key F1 below Setup to open the
System Setup interface.
Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor to Pat. Question on the System
Setup interface, and then press Enter to open the Patient Question interface.
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Next Patient item, and then
press F1 or F2 to select On.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Next Patient item, and
then press F3 or F4 to select On.
3.5 About the System Setup Interface
When the main interface1 is displayed, press the function key F5 below to open the
main interface2. When the main interface2 is displayed, press the function key F1 below Setup to
open the System Setup interface.
Figure 3-7 SE-601B / SE-601C System Setup Interface
Figure 3-8 SE-601A System Setup Interface
On the System Setup interface, press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor to a
button, and then press Enter to open the setup interface related to the button.
Take the Work Mode Setup interface for example:
On the System Setup interface, press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor.
When the cursor is on Work Mode, press Enter to display the Work Mode Setup interface.