EDAN SE-601 Series - Transmitting Files through the Serial Port

SE-601 Series Electrocardiograph User Manual
- 59 -
CAUTION :
It is forbidden to connect or disconnect a U disk or a USB printer during the transmission
course.
8.2.1 Transmitting Files Through the Serial Port
1. Connect the RS232 socket of the PC to the RS232 socket of the electrocardiograph with an
RS232 cable.
2. Or if the PC has no RS232 socket, connect the USB socket of the PC to the RS232 socket of
the electrocardiograph by using the RS232-USB assembly.
Figure 8-7 RS232-USB Assembly
3. Log into the Smart ECG Viewer software.
Note: If you don’t connect the RS232 socket of the electrocardiograph to the PC, or
you do not log into Smart ECG Viewer before transmission, the following hint will pop
up.
4. Select a transmission mode.
Note: If you don’t select a transmission mode before transmission, the following hint
will pop up.