EDAN SE-601 Series - Selecting Antialising (Only for SE-601 B;C); Key Volume; Hint Volume; QRS Volume

SE-601 Series Electrocardiograph User Manual
- 85 -
9.6.3 Selecting Antialising (Only for SE-601B/C)
Press Tab or Shift + Tab to move the cursor to the Antialising item on the Display&Sound
Setup interface, and then press F1 or F2 to select Off or On.
When Antialising is set to On, the system will automatically make the waveform smooth.
When Antialising is set to Off, the system will not make the waveform smooth.
9.6.4 Key Volume
When you press keys on the keyboard, the electrocardiograph gives a short sound. When Key
Volume is set to Off, there is no sound when you press keys.
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Key Volume item on the
Display&Sound Setup interface, and then press F1 or F2 to select an option. You can set Key
Volume to Low, Medium, High or Off.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Key Volume item on
the Sound Setup interface, and then press F3 or F4 to select On or Off.
9.6.5 Hint Volume
When the electrocardiograph displays a hint such as Lead Off, Overload, Battery Weak etc., there
is a sound. When Hint Volume is set to Off, there is no hint sound.
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Hint Volume item on the
Display&Sound Setup interface, and then press F1 or F2 to select an option. You can set Hint
Volume to Low, Medium, High or Off.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Hint Volume item on
the Sound Setup interface, and then press F3 or F4 to select On or Off.
9.6.6 QRS Volume
When an R wave is detected, there is a sound to simulate a heartbeat. When QRS Volume is set
to Off, there is no sound when an R wave is detected.
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the QRS Volume item on the
Display&Sound Setup interface, and then press F1 or F2 to select an option. You can set QRS
Volume to Low, Medium, High or Off.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the QRS Volume item on
the Sound Setup interface, and then press F3 or F4 to select On or Off.