EDAN SE-601 Series - 7.5 Transmitting ECG Data to the PC

SE-601 Series Electrocardiograph User Manual
- 47 -
SE-601A Lead Setup Interface
After setup, press Esc or the function key F5 below to exit the System Setup
interface.
2. When the main interface1 is displayed, press F2 to switch the gain. Press F4 to set the
EMG filter and the Lowpass filter.
3. Press the START/STOP key to begin to count the sampling time. When the sampling time
reaches 180s, it begins to print an ECG report.
4. It will stop automatically after a complete R-R analysis report is printed, or press the
START/STOP key to stop printing the report.
Note: In the R-R mode, you can not set the speed. The constant speed is 25mm/s,
because in the R-R mode, the ECG wave length is compressed to one third of the
original wave length.
7.5 Transmitting ECG Data to the PC
Note: To transmit ECG data to the PC, the Smart ECG Viewer software of the
manufacturer must be installed in the PC. You should log into the Smart ECG Viewer
software before transmission.
7.5.1 Transmitting ECG Data Through the Serial Port
1. Connect the RS232 socket of the PC to the RS232 socket of the electrocardiograph with an
RS232 cable.
2. Or if the PC has no RS232 socket, connect the USB socket of the PC to the RS232 socket of
the electrocardiograph by using the RS232-USB assembly. For details of the RS232-USB
assembly, please refer to Section 8.2.1, “Transmitting Files Through the Serial Port”.
3. Select the transmission mode. For details on selecting the transmission mode, please see
Section 8.2.1, “Transmitting Files Through the Serial Port”.
4. Log into the Smart ECG Viewer software.
5. In the AUTO or RHYT mode, ECG data will be transmitted through the serial port
automatically after an ECG report is printed out.
7.5.2 Transmitting ECG Data Through the Net Port
1. Connect the PC to the electrocardiograph with an Ethernet cable recommended by the
manufacturer.
2. Set the transmission mode and the IP address. For details on setting the transmission mode
and the IP address, please see Section 8.2.2, “Transmitting Files Through the Net Port”.