102
support@edgeovens.com Technical Support: +1 (724) 628 3050
OPERATION
PREVENTATIVE MAINTENANCE
CONVEYOR BELT DISASSEMBLY & CLEANING
FREQUENCY:
Conveyor belt disassembly and cleaning should occur SEMI-ANNUALLY or as needed.
METHOD:
1. Follow steps 1-9 of the CONVEYOR BELT LINKAGE REMOVAL section, for instructions of how to separate
the conveyor belt.
AREA OF OVEN:
• Conveyor Frame
180
FIGURE 3-46
2. Once separated, roll the entire conveyor belt up (Figure (3-46). The
belt can now be submerged in a heavy duty degreaser, solvent or can
be pressure washed.
3. Leave the belt to dry before installing back on the conveyor frame.
FIGURE 3-47
4. Use a solution of mild dish
detergent and warm water to
clean the conveyor drive shafts,
frame and belt support rods.
Depending on the severity of
debris and grease build up, this
can be done using a damp cloth
or scuff pad. (Figure 3-47 and
Figure 3-48)
FIGURE 3-48