ii
support@edgeovens.com
Technical Support: +1 (724) 628 3050
PREFACE
WARNING AND SAFETY INFORMATION
US CUSTOMERS
Oven installation must comply with local codes or, if local codes do not exist, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54.
This appliance must be electrically grounded in accordance with local codes, or if local
codes do not exist, with the National Electrical Code, ANSI/NFPA 70.
This appliance and its individual manual shutoff valves must be disconnected from the
gas supply piping system during any pressure testing of gas supply piping at pressures
exceeding 1/2 psi (3.5 KPa).
NOTICE
IMPORTANT
CANADIAN CUSTOMERS
Oven installation must comply with local codes or, if local codes do not exist, gas oven
installation must comply with the Natural Gas Installation Code, CAN/CGA-B149.1, or the
Propane Gas Installation Code, CAN/CSA-B149-2, as applicable.
This appliance must be electrically isolated in accordance with local codes, or if local
codes do not exist, with the Canadian Electrical Code, CSA C22.2.
IMPORTANT
EXPORT CUSTOMERS
Oven installation must comply with local codes. This appliance must be electrically
grounded in accordance with local codes.
IMPORTANT
Always check for leaks after making any gas supply piping connections or performing
any service on the oven.
WARNING
The installer of this oven must contact local building and re ofcials concerning
inspections and installation requirements of this oven and its ventilation system.
NOTICE
Installing any part(s) not provided by the Edge oven OEM shall void the warranty and
release the OEM from any and all liabilities.
NOTICE
To Next Page
Loading...
Need help?
General
