To Next Page

To Previous Page

4-77

4.6.2 Installing a Depressor Wing and Connecting the Tow Cable

Please see MANUAL ADDENDUM (0021771) DEPRESSOR WING for wing installation and cable connection

instructions. Once completed, continue to C

ONNECTING TO THE TOPSIDE.

4.6.3 Connecting to the Topside

The subsections below describe how to connect the towfish to the topside. Please skip ahead to the

appropriate subsection depending on your configuration.

4.6.3.1 Connecting to the Starmux IV DL

Refer to subsection STARMUX IV CONTROLS, INDICATORS AND CONNECTIONS for the location of the connectors

while performing the steps below:

1. Verify that the Starmux IV DL is not connected to AC power.

2. Verify that the tow cable is properly connected and attached to the towfish, and then connect the

tow cable to the SEA CABLE connector.

3. Connect the Ethernet patch cable to the DATA connector of the Starmux IV Digital Link and to the

ethernet connector of the computer (2U, Getac Semirugged, or user-supplied). This cable may be

extended up to 100 feet using a Category 5 Ethernet crossover or straight patch cable.

4. Set the IP address of your computer to 192.9.0.nnn, where nnn is any integer from 1 to 100, except

for 192.9.0.22, 192.9.0.225, 192.9.0.101, and 192.9.0.102, which are reserved.

5. If a navigation system will be used, connect the navigation system output to an available serial

communications port.

6. If an external source will be used to trigger the Starmux IV Digital Link, connect the trigger output

of this source to the SYNC connector.

7. Connect the AC power cord to the LINE VAC connector and the AC power source.

4.6.3.2 Connecting to the 4205 Rack Mount with Starmux IV DL

Note: The Starmux IV has replaced the Starmux III. This section is included

only to support systems sold with the Starmux III.

Refer to subsection STARMUX IV 4205 RACK MOUNT CONTROLS, INDICATORS, AND CONNECTIONS for the location

of the connectors while performing the steps below:

1. Verify that the 4205 Rack Mount is not connected to AC power.

Edgetech 4205 User Manual

Other manuals for Edgetech 4205