Edwards EXS Series User Manual

Acon
Frequency
Check the purge gas supply pressure and hoses 6 months or 4000 operang hour
s
Check all electrical connecons 6 months or 4000 operang hours
Check and clean exhaust pipe, elbow and check valves 1 year or 8000 operang hours
Replace the blow o valve (BoV) ball
1 year or 8000 operang hours
Replace the electric cubicle lter elements 1 year or 8000 operang hours
Complete overhaul in our service centre 4 years or 32000 operang hours
7.3 Relocate the dry pumping system for maintenance
WARNING:
The subs
tances that accumulate in the exhaust pipe, elbow and check valve (if
installed) can be dangerous. Do not allow these substances to come into contact with
skin or eyes. Do not inhale vapours from these substances. Fit blanking caps to the
inlet and outlet anges when moving the exhaust pipe, elbow or check valve around
the workplace.
The majority of synthec oils/grease can cause inammaon of the skin (dermas).
Safety precauons must be taken to prevent prolonged skin contact with these
substances. Use of suitable protecve gloves and clothing along with a respirator is
recommended if contact with the substance is ancipated. System process gases and
residue can be highly toxic. Take all necessary precauons when handling
components that have, or could have, come into contact with them, including
O‑rings, lubricants and all exhaust accessories.
WARNING:
Suitable liing equipmen
t must be used to move the dry pumping system. It is too
heavy to li by hand.
WARNING:
Remo
ve bulky accessories such as inlet lters, silencers and knock out pots (if
installed) before moving the dry pumping system because they can make the dry
pumping system unstable. Do not exceed the topple angle of 23° when moving the
pump.
CAUTION:
Drain the c
ooling water from the dry pumping system if transporng or storing it in
condions where the cooling water could freeze. Failure to do so could result in the
cooling water freezing in the dry pumping system and damage occurring to the
pumps and/or the cooling water pipelines.
To remove the dry pumping system from its operang locaon and move it to another
locaon to carry out maintenance, use the following procedure:
1. Purge the dry pumping system and shutdown as described in Operaon on page 50
and allow the dry pumping system to cool down.
07/2021 - ©Edwards Limited
Page 57A41870880_A
A41870880_A - Maintenance

Edwards EXS Series Specifications

General

Brand	Edwards
Model	EXS Series
Category	Water Pump
Language	English