Edwards EXS Series - DP Clean High Flow Purge;Solvent Flush (Option)

Pump Ambient (°C)
Water temperature (°C)
40 30 20
EXS450
40
15 SLM
1.8 bar dP
12 SLM
1.5 bar dP
10 SLM
1 bar dP
30
12 SLM
1.5 bar dP
12 SLM
1.5 bar dP
10 SLM
1 bar dP
20
10 SLM
1 bar dP
10 SLM
1 bar dP
10 SLM
1 bar dP
3.7 DP clean high ow
purge/solvent ush (opon)
Table 13 High ow purge/solvent ush data
Feature
Specicaon Rang
Pneumac valve gas sup-
ply
Nitrogen or clean dry air
2.5 - 6.9 barg
(36 - 100 psig)
Pneumac valve inlet con-
necon
3/8 inch compression ng
High ow purge gas
Air
, nitrogen or other inert gas
which is compable with the
process
Typically 185 slm at at-
mospheric pressure at
the purge inlet connec-
on
High ow purge air lter
1/2 inch NP
T male
(available as a spare, refer to
Table: Spares)
DP clean solvent ush u‐
id inlet connecon
3/8 inch BSP male
DP clean solvent sucon
pipe connecon
3/8 inch BSP female
Note:
The DP clean solvent sucon
pipe is supplied with the pump but not ed. Refer to the
instrucon given with the kit to acvate the funcon.
07/2021 - ©Edwards Limited
Page 23A41870880_A
A41870880_A - Technical data